Answer / abdullah

1mm

Answer / rajkumar

0.9mm & 1mm are considered as binding wires.

Answer / sid

18-28 Gage
1-1.5 mm dia

Answer / piyush singh

IN civil Construction/Execution Binding wire used is of 16 to 18 gauge, 

18gauge wire is mostly used and its thickness in mm is 1.02mm.

Leading manufacturer of 18 gauge wire is Tata Wiron.

Also as the gauge increases thickness reduces, so we can say 18 gauge wire will be thinner than 16 gauge wire.

Answer / lokesh

17-18 Gauge

Answer / nishant

.9mm t0 1.02mm

Answer / dubraj kujur

How many types of binding wire

Answer / srinivas

.9mm

Answer / sjtbehera

2mm to 4mm

how to design a formwork for beam, how to determine the load baring capacity of the cuplock system and which is the relevant code for the same.

0 Answers   ACIL,

How Many Brick in One Cubic Meter.

9 Answers   TUV,

Why we select pile foundations

2 Answers  

how much grade of concrete can be used for different structural element such as slab,beam,column,footing & plinth beams? and type of cement can be used in construction work & also types of cemnt grades

2 Answers   L&T,

what is the density of concrete & steel? where we are using pycnometer? what is bulking of sand? what is under reinforced & over reinforced? what is balanced section?

3 Answers  

How much form and scaffolding per cubic meter volume of concrete class ''A'', ''B'', and ''C''

0 Answers  

the construction of building in that primary thing is dig the soil which what depth will dig in stiff soil

1 Answers   L&T,

A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals

0 Answers  

HOW to calculate Rate analysis of M15 GRADE DESIGN MIX RATIO 1:2.5:5 WITH 40MM Size aggregates for 1 cumtr.

2 Answers   Adani,

1) what is the difference between development length & overlap length ? 2) why extras are provided at top and bootom in a beam of slab? 3) why stirrups are provided at 0.3l at supports and 0.4l at center? 4) is column a compression memeber if yes how & beam is which type of memeber?

4 Answers   CDS, HCC, PPL,

how we control the temperature during concreting ?

4 Answers  

appsc AEE'S interview questions wanted

3 Answers   APPSC,