Answer / vijendra joglekar

1 : Power Factor correction capacitors
2 : Improve the load percentage of particular equipment
avoid habbits of using lightly loaded machines which
results large power consumptions i.e.wastage of power .
3: Try using energy savings equipments example in fan
regulator (TRIAC) are used which results it dosent depends
upon the fan speed it will give the same amount of power at
all the times while in old regulator where rehostat are
used which results wastage of power.
Improving power factor is nothing but saving energy
consumptions!!!

Answer / ravirajsinh d jadeja

There are three different methods through which we can improve the power factor,
1. Capacitor (It is used in APFC Panel)
2. Synchronous condenser
3. Phase advancers (It is used for large rating of motors)

Answer / manishjha

adding the capaciter bank.we can improve the power
factor..........

How much area a lightning arrestor can cover?

5 Answers  

---

what will happen if we will not use commutater means if we will give dc to the windings in dc motor

1 Answers  

---

what is the first step of dg shycroning ?

2 Answers   ABB,

---

what is the highest transmission voltage in India till now?

36 Answers   Bhel, Electrical,

---

1. alternator has full load regulation of 4% when pf of the load is 0.8 lag, 1500 rpm. full load regulation of 1400 rpm for 0.8lag will be ________ ?? 2. torque angle of a sync m/c operating from a constt voltage bus is usually defined as space angle between _______ . 3. method most effective in finding out no load losses in large DC shunt motoris ______ . 4. current carrying capacity of fuse material depends on ______ . 5. coil has res. 10 ohm, inductance 1H. what wil be current after 0.1sec after switching on to a 500V DC SUPPL ? ? 6. effect of phase lag compensation on servo systems ___________ . 7. rotor of a dc machine is usually supported upon ______ . 8. DC motor is preferred to AC motor in which application ?? 9. 3 nos of 10:1 Xmer are connected in Star-Delta to supply a load at 230V.the supply voltage must be ______ . 10. voltage source produces max current in which circuit. 11. cal. power, if current and voltage are out of phase by 90 degree. 12. suitable length of Xmission line of power at 66 KV. 13. Which of the theorm helps in simple computation when the load across a ckt is varying ?? 14. what is the adopted line length for power Xmission of power by cables ??

5 Answers   TATA,

---

If 110 volts ac is mixed up ith 12 volts dc what will be the resultant voltage and what is the wave form?

1 Answers  

---

How to conduct the Magnetic Balance test on Power Transformer?

0 Answers  

---

what are smoke detectors ?

4 Answers   Indian Military Services,

---

what ever the ups kva it may 500 kva or 500 va always out put is AC 240 volts its right?

3 Answers  

---

where we use 1 phase & 3 phase supply ?what is major advantage using 3 phase over than single phase ?

3 Answers  

---

if we want to convert the two 12 V DC batteries in parallel for UPS ? what would be the result ? which is better for a UPS , connect two batteries in series or connect them in parallel ?

2 Answers  

---

what is the burdon in case of relays?

1 Answers  

---