What will happen if we give the 3 phase supply to the rotor of slipring inducti

What will happen if we give the 3 phase supply to the rotor
of slipring induction motor?

Question Posted / dharani.3drinku

3 Answers
5351 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What will happen if we give the 3 phase supply to the rotor of slipring induction motor? ..

Answer / sanjeev sharma

Three phase supply can be given to the rotor of slipring
motor for testing purpose. it just work like supply given to
the secondary side of transformer & measure voltage on the
primary side. So give supply to the rotor of slipring motor
& check voltage across stator terminal

Is This Answer Correct ?

3 Yes

1 No

What will happen if we give the 3 phase supply to the rotor of slipring induction motor? ..

Answer / k,prakashchandra

Motor rotates but heavy is current is drawn resulting in
tripping of CB or fuse blow off .

Is This Answer Correct ?

0 Yes

0 No

What will happen if we give the 3 phase supply to the rotor of slipring induction motor? ..

Answer / prince kumar tiwari

in 3 phase induction motor rotor carries the field winding so we are not gived the supply in the rotor supply is always give in the conductor which is in stator

Is This Answer Correct ?

0 Yes

3 No

Post New Answer

More Electrical Engineering Interview Questions

please I wont know how to calculate the vector group for power transformer ZNyn11 best regard.

0 Answers Al Rasikh,

how to calculate singlephase motor efficiency?

0 Answers Alstom,

what is multiplying factor of a energy meter connected with a CT ratio of 600/5 and voltage at 415 volts.

1 Answers

how to set the overload setting in the thermal overload relay?? is there any calculation in that??

3 Answers

what is the function and use of oil filled cables specify its advantages and disadvantages

7 Answers Alstom,

Is earthing done for AC or DC or both?

6 Answers

Why the moulded plug comes with domestic appliances instead of assembled plug like anchor, Vinay 5/15 A.

0 Answers

what gas is present in incandescent and florescent bulbs

4 Answers

the fuse is use for protection against overcurrent but at normal condition it carry the rated current then how single thin wire carry this current without melting

1 Answers

why a motor rating in KW?

7 Answers ABG Shipyard,

in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?

0 Answers

In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?

0 Answers Nissan,

For more Electrical Engineering Interview Questions Click Here