Answer / baskaran

Depending upon model of gas turbine

Answer / crezyd

two thermocouple are used one for bearing and another one for casing

why high pressure heater will take after sufficient pressure? what happen when high pressure heater will take from COLD REHEAT line at light up time when hp and lp by pass in service.(means can we heater take at low pressure?)

2 Answers  

---

what is absolute separator, how it works, what are the types in it

1 Answers  

---

What are the special criteria under which FD fans are switched off during MFT.

1 Answers  

---

How to decide Heating surface area of boiler on their steam generating capacity?

4 Answers  

---

Looking for Bently Nevada surplus 3300/52-01-00-00 Reverse Rotation Monitor , 4 pieces.

0 Answers   OPG,

---

---

In one plant id fan and fd fan are used for boiler. boiler is used to heat water after some days they install one tank to heat water by hot flue gases coming out from boiler and then hot flue gases are used to heat the air coming from fd fan before leaving out from chimney . but hot flue gases are not coming out from id fan what might be the reason?

3 Answers   TATA,

---

a gas turbine have how many thermocouples?

2 Answers   DEWA,

---

We know primary ,secondary air so, What is the work of Tertiary air in Thermal power plant

2 Answers   NPTI,

---

thermal power plants in steam using inlet of turbine.inlet of turbine pressure and flow is same as boiler feedpump why not use direct to turbine?

6 Answers   IBPIL, JSW,

---

why do we use contro fluid tank (cft)in turbo generator area(tg) in power plant?

1 Answers   MPL,

---

What should be the neutral and body grounding sysytem for grid (132 KV) parallel generators (440 volts)?

1 Answers   Rahimafrooz,

---

In turbine. why they not use 320 oil?

1 Answers  

---