During speed control of dc shunt motor with flux control methode,when
armature voltage is constant,
How can it possible to increasing the armature current?
Answer / gurbaj
speed get reduced, as E=V-Ir and E=K*SPEED*FIELD
speed= V-Ir/K*FLUX
| Is This Answer Correct ? | 0 Yes | 0 No |
what will be the effect if you were using different brands of outlets?
excitation limit of an excitor
What is the need for checking knee point voltage for CT's?
Why Neutral Busbar CT & transformer neutral CT connected with phase CT in Restricted Earth Fault?
How the cable size for a motor is decided
why not feeling shock while touching rotor shaft of induction motor during running condition? during running condition emf induced in rotor.
Why corona leads to production of Ozone and glow of the color VOILET?
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
Y phase plates are used in transmission line??? what is there need???
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
What information we need to prepare relay coordination chart
what do you mean by switchgears?
5 Answers Practical Viva Questions,
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)