Answer / kj

As the secondary voltage is induced by the primary current
the frequency will follow each other. Normally the
frequency of the supply is constant so the output frequency
will remain the same.

If the supply frequency changes the output frequency will
follow this change and change also.

Answer / rakesh patel

we maintain the frequency of the transformer is constant because if we change the frequency,eddy current loss and hysteresis loss are also be change with respect to frequency. and due to losses, it is directly affects the efficiency of the transformer.that is why we have to maintain the frequency constant.

Answer / naeem anwar

ok......if we change the frequency in case of
transformer,,,then material or size of transformer will be
large if we decrease the frequency.and vice verca.

Answer / simon

Fq=No.poles*No.of turns/120

Answer / pallvi dogra

There are no moving parts in the transformer i.e. no relative motion. That's why frequency remains constant.

while buying 30 kva on line ups for 1 phase ouput, we ave to calculate the number of batteries for 2 hours back up? how to calculate the ah rating and number of batteries

1 Answers  

Why we specify TNC switch with 1NO 1NC ,2NO 2NC ? how we get connection.?

0 Answers  

why we have to do tan delta test of the transformer oil???

5 Answers  

with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen

0 Answers  

In a 3Ph induction motor(old) 6 wires came out from terminal & not mentioned u1,v1,w1,u2,v2 & w2. how can find out the terminals? how can connect to star delta starter??

1 Answers  

How to design pavement quality concrete by using C.R.C.P Method

0 Answers   L&T,

What is water cooled chiller plant?

1 Answers   Gulf, IOCL,

How many size of cable required for a 300m long and 30kw inductive lode

0 Answers  

How to calculate the value of earth capacitance in a transmission line.

0 Answers  

What is the different between earthing & Neutal

3 Answers  

During the troubleshooting of an inoperative shunt generator, you found the voltage to be 2+ volts; what is known from this. Is it (1). odds are the armature is good (2). odds are there is no field current flowing in field windings (3). odds are the armature is bad (4). both 1 & 2 are correct (5). both 2 & 3 are correct

2 Answers   Air Force,

Why glands not provided for XLPE cables

1 Answers   Saint Gobain,