why we leave expansion joint between to complex
Answers were Sorted based on User's Feedback
Answer / anil kumar prasad
To prevent the developement of crack due to expansion &
contraction of steel & cement with temperature.
Is This Answer Correct ? | 4 Yes | 0 No |
Answer / rishabh thakur
absolutly right, i am agree with Mr. sunil, bcz the material used(cement ,fine etc.) expand with temp.so it should be provided b/w to complex
Is This Answer Correct ? | 4 Yes | 3 No |
RR masonry rate analysis
what is the difference of 53 & 43 grade cement ? expailn
8 Answers Gujarat Alkalies and Chemicals GACL,
Cement require for 1sqm
define the strength
What is difference between FE-415 and FE-500???
i have a bar of 36 dia in column, what is the lap length?
can i make bricks using M10 grade concrete ? and what would be the cost of a brick if we use m10 grade concrete sand and aggregates ??
Can a 9" x 24" RCC beam be supported on 18" x 18" RCC beam.
at the beam-column junction point tell me how much beam bars should pass through column ring ? 3 or 2 or 1 . answer with reason. if it is not happen then what will be he effect ?
How its coming concrete grade M 20 means 1:2:4. how it coming 1:2:4.
where bitumen emulsion is used
What are the specification of good quality sand for plaster and brickwork?