What is the disadventage of gland earthing(power cable) if any. ?
Our Alternator nameplate specifies a power factor of 0.8. When the Alternator is on light load, the bus bar voltage rises to 11240 volts, whereas the standard value is 10500 volts. Is it ok to increase the power factor to 0.85 or 0.9. I am afraid because the power factor on the name plate is only 0.8 ?
why single phase induction motors are not self staring ? how can we start the 1-phase Induction motor ?
what is the difference SCR & TRIAC?
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
Neutral CT for 45MVA 132/11 KV YNd11 Transformer. NCT REF CLASS-PS or 5P20 with 20VA burden which is suitable.
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
how induction motor starts?
I try to check the three phase voltage in multimeter, in 125A isolator switch incommer. first i touch R phase, and then i touch Y phase using multimeter, the moment i touched, it blasts and that moment i got blindness. multimeter selector position is correct(750V AC MODE AND RED PROBE WASS IN v AND BLACK PROBE WASS IN COM. MODE. COULD ANYBODY GIVE ANSWER FOR THIS TO AVOID FURTHER ACCIDENTS PLEASE?
why Copper loss is represented as I square R ?
please explain to me how to calculate current,voltage,resistance with formula??
Why we use Fuse in transformer in secondary side.Why we dont use fuse in primary side?