Answer / k.prakashchandra

To compensate for leading pf

I have 11KV/415V power distribution transformer. I have found unbalance current in LT (415V) side. Also observed that unbalance voltage (3V) at LV side due to HV side unbalance voltage. What should I check for this? Also, the same LV side load can run in balance on captive power.

1 Answers  

---

What is core CT & it's function?

0 Answers  

---

what would happen when synchronous motor will operate beyond syncronous speed?

3 Answers  

---

why dc source used for HV breakers and Relays operation?

2 Answers   Cethar,

---

what are the protections used in power transformers of 5 mva and above

2 Answers   ESRI,

---

What is surger vector in 33Kv transmission feeder? We have AC power generator of 8MW which is paralleled with 33Kv EB grid. Some times our HT breaker gets trip off due to surge vector problem. How to over come it? Is there any device to observe the surge and avoid tripping?

3 Answers  

---

what is PWM in IGBT and how it works for drive.?

0 Answers   BRG,

---

% voltage variation in distribution a)1% b)5% c)10% d)15%

2 Answers  

---

What is burden of a current transformer. What is function of core in Transformer

1 Answers   Jindal Steel and Power, NCC,

---

If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?

0 Answers  

---

During the main stator winding insulation testing (phase to ground)of 11kv alternator (Lerysomer) i found 0 and resistance with multimeter and found 20 killo ohm while the power cables are connected both end (Generator & VCB). In VCB PT (Potential transformer) are connected. Please any body explain that method of insulation is correct or not? also describe of PT connections

1 Answers   Private,

---

WHAT ARE THE DFT AND RMS MEASURMENTS PRINCIPLE IN NUMERICAL TECHNOLOGY OF POWER SYSTEM ?? WHICH IS BETTER IN WHICH QUANTITY MEASURNMENT??

1 Answers  

---