WHY IS CT SECONDARY SHORTED TOWRDS TH EQUIPMENT TO BE
PROTECTED
Answer / engr. kashif
If it isnt shorted it would develop unwanted high voltages across the secondary which might damage the equiment.
| Is This Answer Correct ? | 0 Yes | 0 No |
Can 2 nos. of 1 ton split ac be used through a 20 am supply meter?
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
what is the effect of power factor to (a) voltage (b) transformers (c) generators (d)transmission lines
How much should be the load percentage for 15kva Inverter and Iinut & I output load with Calculations
how to select a breaker (MCB,MCCB,ELCB) for 18.5 kw, 3 ph. 480 v, 60 hz induction motor?
What is the difference between Isolator annd Circuit Breaker.
21 Answers ABB, Lanco, NTPC, Power Grid, RInfra,
block diagram of 2 ups system connected in parallel mode?
When PRV operated at power transformer ,can anybody tell me particular pressure for 50mva transformer plzzz.
Why mostly conductor made by 7 nos wire?
how do find power factor in practically and what it means?
Explain the Term in CT Name Plate – Class: 5P10
i asked a funny question in Electrical ohms law V=IR in const temp voltage is directly proportional to current Power p=VI cos@ in that formula Voltage is indirectly proportional to current Try to give me the fact what is happening in Electrical.. contact Thanigai_1984@yahoo.co.in
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)