Answer / viraj

normally above voltage 10kv called voltage source
their are of two types
1.system generated
when ckt connected or disconnected
2.lightning
lightning stroke over the current caring conductor.
surge current means inrush current
it takes 5 to 10 times current when instrument starts for first time

Answer / sarmadahmed

Surge current is the faulty current produced due to some short circuit and is capable of burning the equipment so earthing is used to provide it a low resistant path for grounding.
Surge current means an instantaneous current of very high amplitude.
Surge voltage would be in case of open circuit condition.

what is mutual induction principle?

2 Answers  

---

How we can calculate the life of Lead acid battery

0 Answers   ABC,

---

what is the function of capacitor duty contactor in an capacitor panel???

0 Answers  

---

Why we are not placing c.B 's btwn generator and transformer.? what happens when generator gets disconnected from transformer when it is running @ full load?

3 Answers   Areva,

---

H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....

0 Answers   Essar,

---

when we are going to higher voltage level in substations why we are using Sf6 circuit breakers instead of Vacuum circuit breakers.

3 Answers  

---

How do i calculate sizing of transformer on didstrubution load for high rise building.What should be MVA Rating of MV Panel feding by 122 kv.

2 Answers  

---

What is the working mechanism of OLTC in Power Transformers????

0 Answers   KSEB,

---

check list of maintenance of transformer?

11 Answers   ABC, Cosmos, EPRON, Essar, Godrej, Hescom, Infosys, KPTCL, TCS,

---

i have 400/230v transformer and didnt done the neutral eatrhing. i connected one lamp to one phase and neutral to the earth. but the lamp is not glowing. again i connected neutral to earth and repeated the same. then the lamp is glowing. in the first condition i tested with a line tester also, at that time the tesrer is glowing what is happening i dont know can any one help me?

1 Answers  

---

why so voltage is same in parallel circuits and current is same in series ckt?

3 Answers  

---

Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!

0 Answers  

---