what kind of material to be used after ngr unit? cu or GI
why induction motor always operate at lagging p.f.?
The ohm is the unit of:(a) Charge(b) Resistance(c) Power(d) Current
What is the most essential condition for the voltage build up for a d.c. Shunt generator?
ganaretors A check B check and C check details
what is difference between electrical and electronics
For Eg a 30 kw motor at full load how much kw it takes And at no load how much KW it will take?
we hav seen in electric engine of trains only 1 wired slidng conecctn is there frm ovrhead line,howevr to complete a ckt in dc postv n negtv two conection has to b there...so where is tht negative is been connectd or where it is grounded...?
we have 400kv/6.6kv transformer ,it has total 9 taps on HV side with normal tap on tap no 5.when we took the ratio test we observed that ratio was decreasing from tap 1 to tap 5 and was found increasing from tap 5 to tap 9.What is the reason?if anyone have related document then please send me on the email id ankushbahale@gmail.com......plz plz
why we multiply 11 in High Electric supply?(eg.11KV, 33Kv, 330Kv etc.)
What is called grain-oriented laminations?
Frequency of rotor emf in induction motor is around A same as stator frequency B 50% C 5 % or below D 30%
Can we convert off line transformer to on line transformer
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)