Answer / baikunth

In any motor the resistance value depends upon its kilowatt
rating. you can calculate the value or measure with a
multimeter.

what is meant by ceiling voltage, ceiling current?? pl reply asap

4 Answers  

---

From stability point of view,What(higher/lower) should be the value of inertia constant of rotating machines?

1 Answers  

---

Do you know the faults occurs generally in motors and how to rectify them?

4 Answers  

---

We have 420volts, Diesel gen-sets each 750kva 4nos. we are operating with bus bar duct having 10x150mm for each face 4nos. our question is what is the minimum gap required between each face? is there any satutory regulations?

1 Answers   Alliance One,

---

Why the isolation treasforfer are connected at out put of the ups ig 200kva ??????????????????

3 Answers  

---

IF we have three 30KW motor, these motors are connected in DOL, star-delta and VFD respectively, what will be the fuse rating for the above three?

7 Answers   DOL, GSK, Ojus,

---

is it possible to step down voltage of single phase from a three phase sysem? explain

2 Answers  

---

Dear sir, we are getting voltage fluctuations suddenly for 2 or 3 minutes again it becomes normal. we checked each and every connection some times we are getting 110 volts like that from earth to neutral again it is reducing we are getting supply from 45 kva DG set give earthing properly.

3 Answers   Triveni,

---

What is partial discharge in power cable?

1 Answers  

---

What will hapen if we run generator below 47.6hz frequency?

9 Answers   TATA,

---

How to know th details about an electrical Drawing ? Please mention the easy method.

0 Answers   Siemens,

---

What is the power factor of a transformer at no load?

0 Answers  

---