what are the reasons for overheating in electrical machines?
Answers were Sorted based on User's Feedback
Answer / viraj
2.could be some jamming problem in shaft
3.it could be single phasing
4.motor winding i2r loss
5.it may be insulation damage
|Is This Answer Correct ?||3 Yes||0 No|
Answer / jagmohan singh
1. Loose connection.
2.cooling fan not available.
3. Bearing life over.
4.one phase missing.
|Is This Answer Correct ?||0 Yes||0 No|
what is the basic principle of operating of a television camera tube?
according to ohms law ,the voltage increases then current is what happened?
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
if AVR fails in D.G set, what will be the effect?
in 33kv/11kv stepdown t/f why should we use Star point
What is the permissible value of earth resistance!
Is it possible to convert Dependent sources to its equivelent current or voltage Sources ?????
WHY DOES NEUTRAL DO NOT CARRY EVEN THOUGH IT CARRIES RETURN CURRENT?
Why are transmission lines multiples of 11? Is it because of some historic reason ? Or is there a scientific base to it?
What will happen if primary of transformer is fed with Square wave instead of sinsoidal wave ?Will it operate or Not?
how to calculate power factor rating according to load? please give the answer in simple language, i'm not electrical side
What will happen if we give DC supply to AC motor?