Answer / tanmay kumar

No,we have to make it manually by reseting the operated relay.

Answer / jaydeep

FIRST OF ALL SWITCHGEAR ARE CONECTED AND THAN AFTER C.B.
ARE CONNECTED B'Z SWITCHGEAR ARE USED TO DISCONNECT OR
RECONNECTION OF THE SYSTEM FROM LIVE ENERGIES .

Answer / yusuf

Once the Fault Cleared the CB Can be closed automatically
using Auto Re closure Relays... Auto reclosing relays are
available on different brands like SIEMENS, ABB and etc.,

Answer / gavin

Circuit breaker miniture as found in a consumer unit or
air as in a switch panel. MCB will not auto reclose as per
BS7671.
ACB will auto reclose using shunt coil but not if earth
fault is not reset first manually

Answer / mg

There is autoreclose function in protection relay(autoreclose relays) if fault is cleared the relay give close command to CKT breaker.

Answer / iqbal.aizza

with the help of springs which are placed both sides of
contacts.

what is difference between earth and ground?/

3 Answers   Sree Rayalseema Green Energy Limited SRGEL,

what is the purpose of reactor in electrical substations ?

2 Answers  

What are the tests carried out on transformer while testing at sites?..Pls explain me in detail

2 Answers   Suzlon,

what are the units of cable insulation?

3 Answers  

what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)

0 Answers   L&T,

which motor is used in high mast ( street light) & give the hight of tower .

2 Answers   Construction, Honda,

what is difference between short ckt and overload?

6 Answers   Siemens,

how to connect from a line-to-line connection to a line-to- neutral connection?

6 Answers  

WHAT IS DEAD END IN PROTECTION?

0 Answers   Ispat, L&T,

substation+ plc system

0 Answers  

how to identify vector group of three phase transformer by voltage method?

0 Answers   AAU,

how we can know the rating of transmission line by no. of insulators disk ??????????

3 Answers   NTPC,