1.what is the reason for transformer and lightning arrester
blast in 33kv system
Answer / rajib kumar chowdhury
If Line voltage increase for line load suddenly off than it can blast [without rainy day].
| Is This Answer Correct ? | 0 Yes | 0 No |
im try to calculating seawater flow required for SW-FGD system. I need a guide, equation or method to do it, can some one help me! Thanks very much
can u please tell me how to calculate the concrete quantity for a under reamed pile? r=300mm,depth=3m for a cylinder and for bulb l=.750mm,width=.525
what is the real reason than natural draught cooling towers are always in hyperbolic shape
Our 8mw steam turbine (condensing cum extraction) exhaust steam temperature is high even after taken it in hogger why
1 Answers Bombay Rayon Fashions,
What is the over speed in turbine? What is critical speed?
Why the steam Turbines are Designed Higher side compare to Alternator
Why cold water is used for Boiler Hydro test
63.5 ohm NGR is connected with our gas engine genrator running at 500 rpm, 50 hz and synched with WAPDA at 6.3 KV bus voltages, 2500A and 25KA(1 sec). can some one give me proper calculations how it comes 63.5ohm?????
whatis means of PPA & FSA OR SFA in power plant operation
Difference between directional earth fault and non-directional earth fault
difference between vaccum pump and ejector
2 Answers NTPC, Tata Steel Limited,
What happen when the AVR of the generator fails? Will it cause power instability and total failure of the alternator?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)