Answer / chandramauli sinh

Manufacturer recommends that it shall be 90 degree to the
pipe, and also recommends that its can be 45 degree facing
towards the direction of the flow.

Check the manufacturer recommendation and the fluid.

Answer / ajith294

I THINK THERE IS NO STANDARD ANGLE FOR MOUNTING THE THERMOWELL,

Answer / yunan

no

In close vessel/ drum why we use d.p. transmitter of -ve range i.e. (-)500 to 0 mmwc.

2 Answers   IMECO, Voltech,

---

Can anyone send most commonly asked interview question in Oil & Gas industry

0 Answers  

---

How to calibrate a orifice differential pressure flow transmitter in process?

1 Answers  

---

How to calculate 47Liter H2 Gas cyilnder consumtion? Cylinder inlet Pressure is 200bar and Discharge pressure is 6.0bar. Flow is 100ml/min.For the above condition how many days one cylinder can be used?

1 Answers  

---

plc trouble shootings?

3 Answers  

---

While giving Power Supply of 24 VDC to a Transmitter,why Shield Terminal is connected either at Transmitter or at ISB.Why not Shield Terminal connected at both ends.If the Reason is to avoid Noise interference,which type of noice that is interfering.Is the Noice from the 24 VDC supply terminals or from any external source.

1 Answers  

---

What is difference between ESD and PLC please Explain me clearly.

0 Answers  

---

Consider a control valve action,the inlet air pressure is only 6 ksc but physically how it can be operate against 100 ksc line fluid pressure?

2 Answers   SCS,

---

what is the difference about HART, and 4-20mA signal?

8 Answers  

---

What is limitation of the ht.of the displacer of a level trol?

0 Answers   CCIE,

---

What is heating effect?

0 Answers   Process Control Technologies,

---

Profibus DP is a multi-master system. Would it work on RS-485 4W or not, and justify your answer

1 Answers   EIT,

---