how many ampere Maxmium load given on a 10 kva DG set?

Question Posted / rnmaurya

3 Answers
7410 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

how many ampere Maxmium load given on a 10 kva DG set?..

Answer / tharan

maximum load given to 13.9 amp....

Is This Answer Correct ?

6 Yes

0 No

how many ampere Maxmium load given on a 10 kva DG set?..

Answer / samuel adegun

The question is not complete,Specify the number of phase(s) and voltage/phase at which u desire to load your appliances.

Is This Answer Correct ?

0 Yes

0 No

how many ampere Maxmium load given on a 10 kva DG set?..

Answer / milind patil

IF the load is single phase then the ampere load is 13A its ok.
But if the load is three phase then the ampere load near
about to 43 A.

Is This Answer Correct ?

0 Yes

4 No

Post New Answer

More Electrical Engineering Interview Questions

what is gas turbine intercooling ?

0 Answers

IN 6.6KV 3 phase switch gear .i will give 6.6kv to R phase only to earth in during H.v testing (through H.v KIT).what happen remaining phases.how much voltage get remaining phases.why? explain.

1 Answers

What is time invariant system?

0 Answers

What r the specification furnishid in motor name plate?

5 Answers

1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?

0 Answers

How to determine the breaking capacity such as break down current and break down voltage for VCB and CT's.

0 Answers

WHAT HAPPENS IF STARTER OF A FLUROSCENT LAMP IS SHORT CIRCUITED AND WE PUT THE SUPPLY ON?

1 Answers

i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.

0 Answers SCM,

how to calculate current and voltage in a same circuit?

0 Answers

A 10 MVA, 66KV, 50Hz, Y-connected 3-phase alternator has synchronous reactance of 0.635 Ù. It is working at full load at 0.8 lagging p.f. condition. Find torque angle, neglect armature resistance.

0 Answers VECL,

WHY FLEXI LINKS ARE USED INBETWEEN GENERATOR TERMINAL OUTPUT & BUS DUCT CONDUCTOR.

3 Answers

why dc supply given to ac alternator rotor

3 Answers

For more Electrical Engineering Interview Questions Click Here