Answer / ravi kumar singh

at the stage of upper yield point the plastic flow in
the material is less than the lower yield point so
stress decreases to upper to lower yield point

Answer / mathavan.s

material property will be change

Answer / abhishek tiwari

due to the tensile stress on the material.

Answer / amritdeep singh

because in upper position the yield point goes to elastic position so the stress is decrease from upper yield to lower yield

Answer / majid

tensile stress

tansen was singer in whose mugal emperor

3 Answers   Concor,

Which questions will be asked for mechanical design Engineer position in GE?? plz give me reply it's urgent...

0 Answers   GE,

what is an intensifier?

0 Answers   IBM,

What is the most important, or helpful,project that you have contributed to?

0 Answers  

what's the difference between front and rear wheel drive?on what basis we choose the type of drive?

3 Answers  

• Have you previously successful in this position progressed to within the company you have worked with?

1 Answers  

hi i m Divyen . i have completed 10+3 in diploma in mechanical Engineering. so can i apply for student visa for canada?

0 Answers  

what is the difference between application of single acting actuator and double acting actuator

1 Answers   H2O, Honda,

Out of electric heater and heat pump, which is economical in operation ?

0 Answers  

I AM DIPLOMA MECHANICAL I GOT CALL LETTTER FROM ISRO AHMEDABAD FOR INTERVIEW CAN YOU GIVE ME ANY RELATED KNOWLEDGE FOR WRITTEN AND PI.

5 Answers   ISRO,

What is the ratio of lenth divergent cone & convergent cone in venturimeter.

1 Answers   DMRC, TATA,

how to implement spc. why we need spc?

6 Answers   Sona, TCS,