I have 200 KVA Isolation Transformer for UPS input side. &
ups was having 48% load, suddenly got short what will be the
reason.
Answer / m.b.parthasarathy
1. You've not mentioned clearly that the short occurred either in transformer or control board.
2. There my be many reasons.
3. In rush voltage may be higher.
4. The device(IGBT) used in the UPS, would be lower value. say 150A/400/600V
5. for ex, the above said UPS, 200kva/480v dc, due to improper maintenance of battery, weakness or prone to ageing the DC may be very low. Instead of 480V Dc it works only in 444V dc. Two or Three batteries may be getting weak.
6. Insulation of the transformer may be worn out
| Is This Answer Correct ? | 0 Yes | 0 No |
what happens if a carbon brush is touching the top end of the commutator
how the fan is switched off immediately switching off the switch?
why can not run two different phase circuit in to the same conduite
why ht11kv supply needs discharging during shut down time
what is voltage rise and voltage drop?
what is merz price protection
What is C check in a diesel generator and what are parts and what has to be done during the C check
What will happen 50 HZ motor when you will give 60 HZ?
7 Answers Bhushan Power Steel,
mcb kitna type ka hata hai aur uska pura naam please bataye
what is joule?
1.what is the contact resistace of CB ? 2.radioactivity should be mesured with---------?
What is knee point voltage?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)