We select 10mm nominal thickness for Elip head of a pressure vesel. The minimum thickness after forming is 8.2mm. (Shell thickness is 8mm. The minimum thickness after forming is satisfied or not with UG-79 (d)(3) in ASME SECTION VIII, Div.1?

0 Answers   PetroVietnam,

---

pls send me rechnical test paper of reliance with answers for last five years??

0 Answers  

---

what is there in altenator which produces electricity?

1 Answers   Torrent Power,

---

difference between pipe and tube

16 Answers  

---

What is the difference between first angle and third angle

1 Answers   Ultra Engineers,

---

why we are using mineral wool as insulation material than glass wool , in india?

0 Answers  

---

What are the causes of dirty lubricating oil?

0 Answers  

---

funtion of leaf spring

1 Answers   Quest, SA, Vijay Industries, VV,

---

800A bus-coupler system

1 Answers   PCEL,

---

INSTEAD OF BSW THREAD, CAN WE USE BSP ON 1"ROD

2 Answers  

---

unit of tensile strength

12 Answers  

---

what are the causes of small two-stroke engine wear?

3 Answers  

---