Hi! Greetings of the day.
Can somebody tell me about as built duct sheet area
calculation method. As we know that for this purpose A =
(W+H)*2*L. But I have query about multiplication factors for
elbows, tappers, offsets etc if there is any. Also refer the
papers if available. Please revert. Thanks in advance.
No Answer is Posted For this Question
Be the First to Post Answer
What is hysteresis
one ball fall from a roof & after two hits of to floor it's reach up to half of the roof height. than what is the cofficient of restitution.
The amount of carbon present in Cast Iron
How cavitation can be eliminated by pump?
In volute casing the discharge area is more. so as per bernoulli's principle the pressure must be reduces also from the basics, pressure = Force/Area. so pressure and area are inversily proportional. By considering these two basic rules pressure must be reduces. But in any centrifugal pump, the pressure is increasing. How the velocity is converted into pressure. In my view only head is increases but how the pressure increases?
What is "the best answer" if any one don't know the answer of any question asked y interviewer?
What are the raw material needed for steel production?
kind of bearing
tell about Automobile engineering
What is fuel oil viscosity, specific gravity?
What is the units of surface tension and also dimensional formula?
sir please provide with the technical papers of mechanical stream at earliest for hpcl exam..or refer any link to get the same??????
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)