Answer / suman chakraborty

First you need to check the excitation voltage which is feed from the controller part then see the mile volt from the load cell side,Then according to the change the load if the voltage changes then primarily the load cell is okay.

Answer / maheshrp

Physically load cell two wire supply and two wire output,so output wire side check resistance that 0.350k it's ok after bad loadcell check resistance 0.450k this is bad
All load cell Wright capacity on load cell

Why the Proximitor supply should be Negative voltage? Why should not we give Positive voltage to the Transducer?

6 Answers   Moser Baer,

---

I HAVE PRESSURE TRANSMITTER WITH TWO WIRES 24 VOLTS SUPPLY.IF TRANSMITTER WILL GIVE SIGNAL TO THE DCS WHAT HAPPEN TO THE 24 VOLTS POWER SUPPLY IT WILL DROP OR REMAIN TO 24 VOLTS POWER SUPPLY.

3 Answers  

---

if field commnictor 475 does not communicate with transmitter what will you do ?

4 Answers   Samsung,

---

Why 4-20mA SIGNAL IS PREFERRED OVEA A 0-10v signal?

5 Answers  

---

how many types of thermocouple cable are? give the name of each type.

1 Answers   Fabco,

---

can any one explain in which term we are flow flow is it volumetric r is it mass? and y

1 Answers  

---

Why is the orifice tab provided?

1 Answers  

---

steps for installing orifice plate?

1 Answers   Bhushan Power Steel,

---

how u measure dp in dp tx? how u calibrate a dp tx?

3 Answers   Invensys,

---

what is instrument termination

1 Answers  

---

Is an analogue only transmitter as accurate as a smart transmitter?

2 Answers   SCA,

---

How would i calibrate a new commissioned flow transmitter???

3 Answers  

---