If the given tractive effort curve and the total resistance curve does not intersect, then a) The vehicle will accelerate b) The vehicle will decelerate c) The vehicle will not be able to go at this gradient for the given gear d) None of the above

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

If two shafts used for transfer of drive are inclined to each other, then a) Slip joint is used b) Flange coupling is used c) Universal joint is used d) None of the above

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

What is back compressor in engine?

0 Answers  

---

how to generate power in engine

0 Answers   TAFE,

---

what is alignment?

1 Answers   ITI,

---

Explain the reason that why the tyres are always black in colour. Is this phenomena related to the heat conduction?

0 Answers  

---

12,6,4 & 3 cylinder engine, fuel firing order & torque capacity

3 Answers   Ashok Leyland,

---

Slip joints are provided in the propeller shaft a) To adjust the inclination of the propeller shaft b) To adjust the length of the propeller shaft c) To prevent the whirling of the propeller shaft d) To adjust the up and down movement of the rear axle

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

can we start the diesel engine with petrol and petrol engine with diesel?(just start not run)

7 Answers   Ford, Honda, PSR Engineering College,

---

frame is distorted in a paralleleogram shape due to--------

3 Answers  

---

The point of interaction of the tractive effort curve and the total resistance curve is called a) Stabilizing speed point b) Low speed point c) High speed point d) Normal speed point

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

What is the main task of batter in an automobile?

0 Answers   John Deere,

---