If two shafts used for transfer of drive are inclined to each other, then
a) Slip joint is used
b) Flange coupling is used
c) Universal joint is used
d) None of the above
No Answer is Posted For this Question
Be the First to Post Answer
The main disadvantage of sliding mesh type of gear box is a) High noise level b) Low mechanical efficiency c) High skill required by the driver d) all of the above
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
What is overflow and how it's happen
How to calculate the speedometer ratio in the vehicle?
What are the different alloys of brass?
basic difference between bsIII & bs IV
What is dtsi?
Which conduct faster heat among steel, copper and brass?
The land rover 110 defender stop because someone put water/kerosene in a fuel system,what can I do in order the to run again...
In case of a constant mesh gear box, when the left dog clutch is slid to the left by means of the selector mechanism, a) Direct gear is obtained b) First gear is obtained c) Second gear is obtained d) Reverse gear is obtained
0 Answers Backbone, Bosch, MAHINDRA, Uniparts Group,
what is the formula for calculating BHP IN SI UNITS
What is engine efficiency?
why we use ignitor in ignition coils in automobile sector?
2 Answers DE Diamond Electric India,