Answer / carl_ellis

The general rule of thumb is to put the working range in at
the mid-range of the scale of the pressure gauge.

Remember, a bourdon tube is damaged beyond repair when
overpressurized.

Alternative rules are
If the working Range is
- Steady: the working range can be 3/4 of full scale value
- Fluctuating: the working range should be 2/3 of full
scale value
- Full scale value: the gauge is working near its limit.
Short duration at full scale value is advised. Replacement
with a higher range gauge is advised.

Typical standard dual scale gauge dial ranges are shown below:

kg/cm2  psi
0-1.06 0-15
0-2.1 0-30
0-4.2  0-60
0-7     0-100
0-10.6  0-150
0-11.0 0-160
0-14   0-200
0-21    0-300
0-28   0-400

The 0-11 bar-Kg/cm2 range puts a 6 kg/cm2 working value just
above mid range.

Yeah, yeah, I know. 1 bar is not exactly 1 Kg/cm2 but we're
talking mechanical gauges here.

Carl Ellis
Measure First

i am working in the automation company...i want to just know how actully pid control valves are tune????...

1 Answers  

---

A RANGE OF TRANSMITTER IS (0-400)B mm abs what is "B"?

1 Answers   HCL,

---

what is the reason while warning lamp is on while the engine is cranking?

0 Answers   Jindal,

---

How to Calibrate Flow Switch in field

0 Answers  

---

NAME ANY TWO ELASTIC PRESURE SENSOR?

2 Answers   DVC,

---

What are advantages and disadvantage of the ac supply load cell?

0 Answers  

---

How does SmartPlant Instrumentation interface with physical design (3D modeling)?

0 Answers  

---

Tr. Wiring for calibration.

0 Answers   CCIE,

---

A pressure transmitter with a range of 0-100 bar.The accuracy of the instrument is 1% of upper range value? The pressure indicating transmitter is showing the system pressure is 50 bar. b. When you include the error, what is the minimum possible pressure in our fuel gas system? i. 49.5 bar ii. 49 bar iii. 1 bar iv. 0.5 bar We want to change the filter cartridge. We must depressure the fuel gas system. c. After we depressure the system in preparation for maintenance, the transmitter displays a pressure of +0.1 bar. At this time, what is the possible range of pressures in our fuel system? i. +0.099 to +0.101 bar ii. 0 to +0.2 bar iii. -0.1 to +0.3 bar iv. -0.9 to +1.1 bar

3 Answers  

---

temptrure me ketne frequiency hote hai

0 Answers   ME,

---

The DCS has the following signal type:

3 Answers  

---

I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.

0 Answers  

---