Interested to Buy Any Domain ? << Click Here >> for more details...
SUPPOSE A CIRCUIT BREAKER HAS TRIPPED THE THE LINE WHEN A
FAULT OCCUR ON IT.NOW WHEN THE FAULT HAS BEEN CLEARED, HOW
THE CIRCUIT BREAKER WILL CLOSE AUTOMATICALLY NOT MANUALLY.
- 6 Answers
- 8957 Views
- Bureau of Energy Efficiency, DVC, I also Faced
- E-Mail Answers
Answer Posted / yusuf
Once the Fault Cleared the CB Can be closed automatically
using Auto Re closure Relays... Auto reclosing relays are
available on different brands like SIEMENS, ABB and etc.,
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
What is the formula for calculating impedance of transformers connected parallel at fault level 50KA?
what mean by analog ,digital,numerical meters and relays? say the example?
what is the criterion for selecting vector group of Transformers ? i mean how to decide vector group of Generator transformer, substation trasformer and transformer at consumer end
i have 3500 amp load and select current transformer and perches.how i calculate .please understand
state the working of discharge lamp?
What is the use of oil in transformers?
How to know Resistance and Reactance value of main and aux winding of single phase capacitor start capacitor run induction motor to find capacitor value?
explain PV modules in solar energy generation.
What are the necessary solutions needed to be carried out on a malfunctioned earthing mechanism of a VACUUM CIRCUIT BREAKER.(TAMCO)
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
What is the pro & con of having 11kv & 33kv incoming, and what is the adv & disadv. of converting from 11kv to 33kv.
what is the Earth Voltages in Power Plants, Sub-stations, Industries, Residential & Commercial Buildings.
can some one clearly explain why -48 volt DC use in telecom site????
1)we have 1000 cfm Blower,Dia-1Mtr,Velocity of air 94 m/s 2)We have Natural Air velocity 94m/s 3If i Put Wind Mill in natural air ,speed is 94m/s Then it will generate Assume 100kw 4)If i put same wind mill across the Blower,air speed is same 94m/s now the Question is Will it generate 100 kw?
how to calculate voltage drop and followed by cable calculation?is there avail in formula?
