Answer / nishant2110

Actually, Power rating generally comes in multiple of 11,
because of form factor.
Since form factor of sinusoidal wave is 1.11
So, wherever(generally in ac system) rating is given in RMS
value, they must have to multiply average value with
formfactor(1.11) and it comes as multiple of 11.

Now come to the real question,

Since, In Railways, DC series motor is used.
So, no need to specify rating in RMS values. That can be
specified in Average value. That's why, it is not in
multiple of 11kv.

Guys, this is my perception but i believe this is right
answer. Anyways, discussion will be appreciated.

Answer / kavita

any one know above answer............plz give correct answer
of above question

1.what is the funtion of chiller primary & scondary pumps. 2.what is the use of distribution lines & Types. 3.what is the use the thermal power stations & how much capacity.

0 Answers   Wipro,

---

for 644KW load which MCCB should i use

6 Answers  

---

SUTIABLE FOR ohm's law super conductor

0 Answers  

---

Isolation transformer primary to sec turns ratio?

2 Answers  

---

what is the difference between ups & inverter

4 Answers   Cushman Wakefield, Dana Group,

---

EHV current carrying parts need to have smooth finish,then how can a 245kv GIS with emery finish can run so long?

0 Answers  

---

why capacitors cant used in genset to maintain power factor..??

2 Answers  

---

Why the voltage n frequency of the incoming generator is kept slightly higher than d grid voltage n frequency while synchronization ?

4 Answers  

---

why the efficiency of generator is more than the motor in case of swinburne's test????

1 Answers  

---

what is the differance between ac induction motor and ac synchronous motor?

5 Answers  

---

Why no-load primary current is very small as compared to full load current in transformer (as 1% of full load current?

5 Answers   NTPC,

---

if the stetor speed (N S) increase by 20% then the rotor speed will be increased by 20% is it true. ?

4 Answers  

---