if the slab is 2 way then,where we will put lapping upper
and lower side?means near to beam or center and near to
center?
- 2 Answers
- 4124 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / nadim
CENTER because if we put it near or near to centre it wil not transfer the load onto the beam
| Is This Answer Correct ? | 1 Yes | 3 No |
what are the Task work of different labour.?
what"s the sort of beams?
An invisible line should intersect a visible line with
1 Answers PSCI, SPC Systems, PSC,
ratio of sand, cement and metal in all concrete mix
m30 mix proportion as per IS code
how many bags of cement required in neat cement finish per square metre
how to distinguish TMT n Tor steel?
what is the load capacity of bored pile pile dia 500mm
What is the Maximum & Minimum size of rod using on the column?
is there any influence of water(used for mixing of concrete) on a weight of harndend concrete.
What is the strength of 1:6:12 mix?
manhole height is 1500 mm and width of brickwork is 230 mm dia of manhole covering is 560 mm brick masonry 1:4 horizontal length is 1500 mm and plaster 12 mm thick on both side 1:3. how to estimate the quantity of brickwork with mortar cement and sand for manhole chamber.
-
Civil Engineering (4643) - Mechanical Engineering (3703)
- Electrical Engineering (15783)
- Electronics Communications (2638)
- Chemical Engineering (762)
- Aeronautical Engineering (79)
- Bio Engineering (30)
- Metallurgy (95)
- Industrial Engineering (199)
- Instrumentation (2882)
- Automobile Engineering (171)
- Mechatronics Engineering (41)
- Marine Engineering (62)
- Power Plant Engineering (170)
- Engineering AllOther (1335)
