What are the advantages of using distance protection
schemes as opposed to normal overcurrent/ earth fault
protection on high voltage feeders.
No Answer is Posted For this Question
Be the First to Post Answer
why we use single core 630mm2 cable for transformer secondary side
in 220 kv substation,what is the mean of avr voltage reading? means at oltc temp. 36 the avr voltage was 109v.so what the mean of 109v
what is the solution for meger test failed the MV cable?
why phase & neutral is use in tv? why earthing not use ?
A LT ckt i mean 440 volt flow of current100A.at this time HT current what will ON 11 KV &33 KV.plz givemy answer with example
photo conductive cell
what is the working principle/operation/theory of 3-phase rectifier power transformer used in cold rolling mills.
For Eg a 30 kw motor at full load how much kw it takes And at no load how much KW it will take?
Describe the test procedure to determine the vector group
if our motor load is 150 amp v- kv and we want to install capacitor bank then what is the exact value of that capacitor bank that we should install?and how we calculate that
How can find thermal state value in relay for calculate thermal overload.
Why the wave trap is put in Y phse only in switchyard?why not in other phases?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)