What are the components of a substation?
Answers were Sorted based on User's Feedback
Answer / venkat.v
transformer, poles, LAS, ISOLATORS, AB SWITCH EARTH PITS,
BATTERY CHARGER,
ACSR CONDUCTOR, INSULATORS
Is This Answer Correct ? | 3 Yes | 0 No |
Answer / abhishek goyal
ACSR conductor according to 132KV 2wire, panther, zebra etc.
Towers , isolator, LA, wave trap, PT, CT, SF6 ckt
breaker,transformer, meters, electrical or control
Panel,earthing, earthing mat or grid, battery charger with
battery for backup supply or control supply, neutral
grounding resistor, capacitors banks,control room, panel
room, SCDA and Cables HT/ LT.
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / sanjay verma
GENTERY,TWO OVER HEAD EARTH
POLE,L.A.,PT,CT,METER,ISOLATOR,CT,PT,POSTINSULATOR(FOR
REQUIRED),LA,TRANSFORMER,ONE OVER HEAD EARTH POLE,YOUR
SECONDERY CONNECTION. EACH EARTH POLE ARE CONNECTED IN SUB
STATION BASED EARTHING.
Is This Answer Correct ? | 0 Yes | 1 No |
HOW TO DESIGN THE body EARTH cable(Copper Conductor) size for 60KVA UPS?
Dear sir, By which formula u can calculate for a particular kv line there is a range of mw.
What is pole of the system?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
Why design 150Hz in Exciter
can we connect PARALLEL 2 D.G set with different rating?? How ? What is the requirement for this connections?
what is a difference b/w earthing & neutral?
What is the difference between a verilog task and verilog function?
Why is the diffrential protection in DG. What if the CT polarity is reversed while connecting for the same type of protection? How polarity can be made ok?
How to calculate the Meter constant for the given Meter (by using any formula)
Will any motor burn if voltage provided is lesser than the rated voltage???? If yes, then how is speed control possible with voltage control
What is the difference between newtral earthing and body earthing?
3 Answers JK Lakshmi Cement, NPCIL,