Answer / basha.shaikkhasim

Air should be cooled with cooling water and m/c will be
required oil specifications.

What is a good source of equations for calculating discharge flowrates from accidental releases?

0 Answers  

---

What are advantages using hollow shaft impeller?

0 Answers  

---

For amonia manufacturing process if pressure, temperature would be increase over optimum level what would be happen?And what steps should be taken?

0 Answers  

---

What is the practical particle size limit for pneumatic conveying?

0 Answers  

---

How much will be the increment for postal assistant yearly?

0 Answers  

---

hai....i am chandrika. if anybody having test questions for HAL,HPCL,ONGC,IOL...PLS SEND THE QUES WITH SOLVED ANSWERS TO ME TO MY MAIL ID chandrismiles@yahoo.co.uk

0 Answers   HAL,

---

Question 76 - Let C% be the fractional crystallinity, Rs = density of sample, Ra = density of amorphous form and Rc = density of crystalline form. In a polymer, these unknowns could be related by the equation C% = (Rc / Rs) (Rs - Ra) / (Rc - Ra). (a) Find the equation of Rc as a function of C%, Rs and Ra. (b) Two samples of a polymer, C and D exist. For sample C, C% = 0.513 when Rs = 2.215 unit. For sample D, C% = 0.742 when Rs = 2.144 unit. Both samples C and D have the same values of Ra and Rc. Find the values of Ra and Rc in 6 decimal places.

1 Answers  

---

What are the effects of oils on the properties of Polyolefins?

0 Answers   IOCL,

---

THERMODYNAMIC - EXAMPLE 10.1 : The water is superheated steam at 440 degree Celsius and 17.32 megapascals. Estimate the enthalpy of the steam above. From the steam table for water at 440 degree Celsius, enthalpy of steam, h at 18 megapascals is 3103.7 kilojoules per kilogram and at 16 megapascal is 3062.8 kilojoules per kilogram. Assume that h = mP + c where P is pressure; m and c are constants at fixed temperature with small differences in P.

1 Answers  

---

if i added hypo before DM plant so i will affect my resins of anion or cation. if affect it so do prevent what kind of step should be taken to remove hypo before DM inlet?

0 Answers   Hindustan Unilever Limited,

---

Explain the different characteristics that can affect the flow of bulk solids and how?

0 Answers  

---

X is a solid having a white colour at room temperature. It has a density about 2g/cc. Although it has melting point near 325 degree Celsius, its properties start degrading above 260 degree Celsius. The coefficient of friction is very low about 0.1. It has very good dielectric properties especially at higher radio frequencies. It has a very high bulk resistivity. It is chemically inert. It is also resistant to van der Waals force. It is hydrophobic as well as lipophobic. Creep or ‘Cold Flow’ has been observed in X.

0 Answers   Ford,

---