How many double suspension hardware fittings are required on
a double circuit transmission tower?
No Answer is Posted For this Question
Be the First to Post Answer
What is mean demand of the Plant?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is onbserved the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
How much difference can there be between HT & LT KWH unit consumption at the same load?
how to cal calculate capacitance in DC Circuit
what is 3rd Harmonics? how it is generated in alternator
Does power factor vary with speed?If yes, how?If not, why?
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
WE HAVE A LOAD OF 55KW MOTOR ITS VOLTS 380 3PH AND ITS TAKING 100AMPS (ITS FULL LOAD IS 105AMPS)AND ITS CABLE IS 4CX50SQMM ,NOW ITS GETTING ABNORMAL HEATUP IN CABLE,PLZ TELL WHY ITS HEAT-UP?(CABLE LENGTH IS 15 METERS ONLY)
Do you know how to connect a motor of different H.Ps?
what is the basic principle of the alternator ????
what is phase voltage and phase current what is line current and line phase
how does the thyistor work in dc drive?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)