Answer / krupa s

clipper is the circuit it removes the unwanted portion of
the waveform (voltage)
clamper shifts the Signal(voltage) to the required level
Both are electronic circuits.

Answer / priotom dalani

CLIPPER : IT IS AN ELECTRONIC DEVICE THAT CLIPPS OFF OR REMOVE AN UNWANTED PORTION OF INPUT SIGNAL WITHOUT DISTORTING THE REMAINING PART OF THE WAVEFORM. THE CLIPPER WHICH REMOVES THE POSITIVE HALF CYCLE OF THE IN/OUT SIGNAL IS CALLED NEGATIVE CLIPPER.
CLAMPER : THE CLAMPER CIRCUIT DOESNOT CHANGE THE PEAK TO PEAK RMS VALUE OF THE INPUT WAVEFORM. HERE THE WHOLE SIGNAL IS EITHER SHIFTED UPWARD OR DOWNWARD FROM THE REFERENCE LEVEL,ACCORDINGLY ,IT HAS BEEN CLASSIFIED AS POSITIVE AND NEGATIVE CLAMPER RESPECTIVELY.

how much insulation resistance 11kv & 33kv under ground cable between earth to phase & phase to phase.

4 Answers   Siemens,

---

can we use breather in a SEALED power or distribution transfomer instead of injecting nitrogen.

1 Answers  

---

1.difference between sts & ats? 2.what is fm200 system brefly explain?

1 Answers   Ericsson,

---

Dear all i want to know SEWA Electrical Supervisor Licence test Previous Year Questions ? If any body know please send to me zohairaukllah@yahoo.com

0 Answers  

---

What will happen if the 50HZ Transformer is connected with 60HZ power Supply

2 Answers  

---

cable selection formulas for electrical load.

1 Answers   Bhel,

---

what is meant by LCR meter? where its useful ?

0 Answers  

---

Ehat is shunt motor?

4 Answers   L&T, Siemens,

---

I have current, kva How can calculate kv?

3 Answers  

---

ult of expression 'document.FrmQF.myem

0 Answers  

---

what should be 3phase motor capacity or rating to connect in star connection. what should be 3phase motor capacity or rating to connect in delta connection. what should be 3phase motor capacity or rating to connect in star delta connection

1 Answers  

---

I need tnpsc AE Electrical question papers

2 Answers   TNPSC Tamil Nadu Public Service Commission,

---