Wats the purpose of lap length? Is it for strength or
increasing of span
Answer / saif raza
lap is provide for proper bonding of two material to
increase the srength at joints.
| Is This Answer Correct ? | 20 Yes | 0 No |
what is the code for classification of bricks
How to calculate soil bearing capacity of soil?
why shear is not considered in limit state of serviceability??
what will be the cost of constructing a plinth of (40x40x4)ft and a PCC layer of 4 inches?
HOE TO YOU PLAN TO ACCHIEVE THE GOALS?
How to calculate cement quantity in m20 concrete
2 Answers nnovative Constructions, Shapoorji Pallonji Group(SPCL),
In case of concrete cube test were all three molds are attached together do you cast your cubes simultaneously at the three molds every 50 mm or one after the other?
1)What is Suggested type of cement for concreting at water, for mass concreting and where the chaces of gettin attucked by salt? 2)How many types of camber? 3)why we always preffer short column in case of residential building? 4) Is there any advantages between the use of One way slab & two way slab? 5)What shoul be the % of steel for R. C. C. perpose based on volume & area ?
where we provide hinged joint in a framee structure ?
what is the ratio of steel and concrete to use in slabs , beams, columns ?
what is M20 ?
3 Answers L&T, Sukhwani Constructions,
Explain the mechanism of cavitations in pipes and drains?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)