what is power factor

Question Posted / sreekantareddy

4 Answers
6540 Views
UltraTech, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what is power factor..

Answer / patel_rakesh2089@yahoo.in

power factor is the cosine angle between voltage and current.

Is This Answer Correct ?

8 Yes

2 No

what is power factor..

Answer / bipin gond

the ratio of real power and the apparent power.

Is This Answer Correct ?

3 Yes

0 No

what is power factor..

Answer / vishal

kw/ kva

Is This Answer Correct ?

2 Yes

1 No

what is power factor..

Answer / sharad pandey

Power factor >the cosin of angle between voltage and current in ac system is called power factor

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.

3 Answers

Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.

0 Answers

What are the different pre-commissioning tests that are performed on the distribution transformer, power cable and switchgear (11kv)?

1 Answers Hitech, Reliance,

what will happen if OLR CT in all phases are short circuted

0 Answers Indfrag Limited,

why we use bare wire in high tension power instead of using insulated wire?

2 Answers

How much of the total hydro power potential has been exploited so far in india?

0 Answers

While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply?

2 Answers

How can we calculate strength of copper hich is supplying electric power to heater and in it hold the heater also and what r all types of forces which is acting on it...

0 Answers ABB,

WHY CBCT USE ONLY IN Y PHASE NOT OTHER PHASES

0 Answers

we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain

0 Answers TNEB Tamil Nadu Electricity Board,

hi i have a 400kva transformer i want to know the test i can use to check on it thx

1 Answers

How does a transformer contribute towards the widespread popularity of ac system over dc?

0 Answers

For more Electrical Engineering Interview Questions Click Here