In layman terms, what is the difference of Dielectric
strength and dielectric constant when speaking of an
insulating oil
No Answer is Posted For this Question
Be the First to Post Answer
why the secondary current transformer cannot left open
is it possible to use a tranformer to regulate an unstable system voltage?
Hello sir This is prakash from bangalore i have a doubt why we have to maintain DG power factor in the range 0.78 to 0.8 Perhaps i f it is increased means what will happen in DG
in 33KV or 66KV system which connection is aviable on high voltage transformer primary delta or star ?
what is the 2MVA distribution transformer efficiency
what is difference between c-power & u-power air circuit breaker?
2 Answers Areva, IIT, Marine Electricals,
what is the significance of terminal voltage and phase sequence in the operation of paralleling of two generators?
how to choose cable size with respect to load? how to convert cable size in mm2 to sq.mm?
what factor is necessary during design of HT & LT MOTORS.
What is basic impulse insulation level? And how it is calculated for sub- station?
if dc is better then ac...then why we are perfering ac over dc?eg:at home?
Dear sir, we are getting voltage fluctuations suddenly for 2 or 3 minutes again it becomes normal. we checked each and every connection some times we are getting 110 volts like that from earth to neutral again it is reducing we are getting supply from 45 kva DG set give earthing properly.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)