why using 3 phase
Answer / arif latif
in modern transmission and distribution we use 3 phase bcoz
its economically best and more efficient compare to single
phase or two phase.
| Is This Answer Correct ? | 3 Yes | 0 No |
How do we calculate the maximum amount of current in a 300 SQ.MM cable ?
An automatic water heater is an example of which type of control system?
When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?
15 Answers Bhel, Sail, Sterling Telecom, TCS,
rajha power sector details
what is the most probable reason of failure of current transformer?
What is the best thing to protect the motor from running over full current. CT or O/L or pressure transducer at the given pressure rating
For Bus duct hi pot test, where we want to connect the return and ground leads?
what is difference of electrical and electronics
What is the difference between online ups and offline ups?
44 Answers Electrical Tech, GMR, Gravity India, HCL, Indus Towers, NIT, Pyramid, Techno Electric and Engineering, UBS,
Resistor switching is used in which type Circuit Breaker ? a) oil filled CB b) Air blast CB c) Gas filled CB
11 Answers Engineers India Limited, wbsedcl,
what is meant by crawling??
When we need up only in o/p 440v, so why we use directly in 11kva in input?
0 Answers Lupin, Medhaj Techno Concept,
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)