Which element is highly conducting coppoer or gold?

Question Posted / siva e

3 Answers
5205 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Which element is highly conducting coppoer or gold?..

Answer / siva e

gold

Is This Answer Correct ?

10 Yes

5 No

Which element is highly conducting coppoer or gold?..

Answer / k.prakashchandra

The resistivity(rho) of copper is 1.68 x 10^-8 ohm-m and
that of gold is 2.44 x 10^-8 ohm-m.

Is This Answer Correct ?

3 Yes

0 No

Which element is highly conducting coppoer or gold?..

Answer / k.prakashchandra

A low resistivity indicates a material readily allows the
movement of electric charges.The resistivity of silver is
1.59 x 10^-8 and it is the best available conductor of
electricity.

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

How to choose primany and secondary side MCB

1 Answers

WHY HVDC?

3 Answers

What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)

0 Answers

What is the safety factor is to be consider while selecting the switchgear and protection for electrical system

1 Answers

advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor

0 Answers

i need project topics along with circuit diagram in the electrical and electronics engg and also some websites regarding projets.

2 Answers

what is the maximum demand how it is defined

1 Answers

3.The slip of an IM UNDER FL condition is about.....

1 Answers SSC,

Why Exciter higher ferquency ?

1 Answers Core Logic,

One of our gas turbine generator unit "1st stage rotor ground fault" alarm was occured several times. we tried to measure some voltage vulue ground fault protection relay (UNS3020a made by ABB and we measured the value of: Ground: 0.9VDC 5V: 5.8VDC 24V: 23VDC u+: 300 – 350mVAC Rf1: 17.5mVAC Rf2: 17.6mVAC The unit still running and the alarm was reset. As of 6pm yesterday and unitl now no alarm happened again. I our protection relay was defective?

1 Answers

HOW BETTER VOLTAGE REGULATION IS OBTAINED BY HIGH VOLTAGE TRANSMISSION....?

1 Answers Cummins,

in our all power plant have connected in grid and grid voltage and plant voltage is same, but as per as electrical concept the power will transmit from high potential to low potential but here altough same,then how power transmit from power plant to grid.

0 Answers

For more Electrical Engineering Interview Questions Click Here