if a centrifugal pump
system is already
installed and later
found that cavitation
occurs, how to fix it
without disturbing
system by much?!
Answers were Sorted based on User's Feedback
Answer / yatin
we need to provide vent valve is discharge line to drain
material untill product does not come from this vent line.or
need to check material boiling point then we should insulate
sunction line & tank or try to apply NPSH (Net Possitive
Sunction Head)
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / c
Cavitation occurs if NPSHA < NPSHR, Cavitation can be
eliminated by increasing NPSHA or Recreading the NPSHR
| Is This Answer Correct ? | 2 Yes | 2 No |
Answer / ab_ina7
we will have to change the impeller...no other way..
| Is This Answer Correct ? | 0 Yes | 2 No |
What do you understand by eutectic ?
How does turbine work?
What is the use of gravity disc?
Hi any one can help in preparing for BHEL ET exam in mechanical stream? I like to know the the question paper pattern fro the same. regards, Jose 9841327666 josevinoth@yahoo.com
What is the b check value of a 4bt engine
on volume basis,air contains following parts of oxygen
can we say all tapered pipes as nozzle?
What is the difference between EN 8 and SS410 grade material with chemical composition and application.
heat transfer by radiation can be increased by?
what is powercopy in catia v5
what is machnical interlock? explain the uses.
What is entropy
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)