Interested to Buy Any Domain ? << Click Here >> for more details...
if a centrifugal pump
system is already
installed and later
found that cavitation
occurs, how to fix it
without disturbing
system by much?!
- 5 Answers
- 10490 Views
- L&T, MAHINDRA, I also Faced
- E-Mail Answers
Answer Posted / c
Cavitation occurs if NPSHA < NPSHR, Cavitation can be
eliminated by increasing NPSHA or Recreading the NPSHR
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
What are the causes of low compression in the main engine?
Hai, iam renjith. my qtn about the calorex heat and cool pump. What is the reason of the above machine is trip on high pressure. r134a gas using in this system. 8 months old. model is calorex propac 90(3 phase). This system has 2 compressor. Both are starting on 13amps after that rise up to around 21 within 1 minute. After will be trip on high pressure. Showing 68 psi in suction side on standby mode. Can i have a solution without delay? Renjith renjithngm@gmail.com
tell me about a time you were able to successfully deal with another person even when that individual may not have personally liked you or vice versa.
What are four types of turbine seals?
what's the difference between front and rear wheel drive?on what basis we choose the type of drive?
For a high pressure/ high temperature multistage pump (Boiler Feed Water Pump), what is the average life of mechanical seal? Does life of DE and NDE differ, if differ, how much? Why?
i want sample question paper for SECTION ENGINEER IN RRB.
How we make bend & diffuser from any pipe (it's equation)& how we mark in pipe....
Which pipes are used for steam lines?
What is a time and motion theory?
What is difference between Higher calorific value and lower calorific value?
what is the pattern of written test for the post of trainee mechanical engg.
What resistance the ship encounter when the vessel is at sea
what is routh,s law in thermal engineering ?
How can you convert air mass to air volume?
