Answer / srinibe

The applied load divided by the bearing area. Maximum
bearing stress is the maximum load in pounds, sustained by
the specimen during the test, divided by the original
bearing area.

Answer / karthick

the stress which acts on the contact surface area between
two members is known as bearing stress.an example for this
is the stress between nut and the washer

Answer / jayaa

total load divided by projected area of contact of braring

Answer / pankaj singh

it's the stree that result to from contect of two member
.The equation to determine average bearing stress would be
sigma b.s = P/A where P is the force applied to the member,
and A is the contact area of the object resisting the force.
The SI unit for bearing stress is Newton/meter2 which
equates to Pascals (Pa).

What the function of bye pass filter in DG.

0 Answers   Honda,

---

what is the difference between c.o.p. And efficiency. Why c.o.p of heat pump is greater than refrigerator

4 Answers  

---

What are the symptoms of broke piston ring?

0 Answers   RRB,

---

what is the procedure to start the turbine?

0 Answers  

---

what is pulverisation

6 Answers   GNFC,

---

What is difference between Higher calorific value and lower calorific value?

0 Answers  

---

which one of the following loading is considered for the design of axle. 1)bending moment only 2) twisting moment only 3) combined bending moment & torsion 4) combined action of bending moment & axial thrust

2 Answers   APPSC,

---

WHAT IS MEAN BY SS-314(STAINLESS STEEL PIPE GARDE)?

1 Answers  

---

In a four-stroke diesel engine, In what engine exhaust valve will open?

0 Answers  

---

i having 7.5 kva 1 phase genset,coolant water level is low, so i mix the normal water this is correct or not

1 Answers  

---

what is the reason? if centrifugal pump is not discharge the water or not suck the water in running condition.

6 Answers  

---

What is the difference between newtonian and non-newtonian fluids?

0 Answers  

---