Answer / Sandhya Tripathi

Answer this question by identifying the primary causes of energy loss in factories, such as inefficient machinery, poor insulation, excessive heat loss, and improper maintenance. Explain how each factor contributes to energy waste and suggest potential solutions.

what is (+) and (-) in generator field detector stand for?

1 Answers  

---

how the speed of the gets motor regulated. does it draw the same current on the all speed level.

1 Answers   Danko,

---

solar inverters was not connected to the nuteral link .this nutwral possible to any other systems

1 Answers  

---

sir please send me previous year questions of jspl of electrical section through which i could prepare myself fpr the test.

0 Answers  

---

What is meant by power factor correction?

5 Answers   Aspire,

---

why T/F winding temp measurement cts are odd secondary current ie,109A/1.2A/1.4A?

1 Answers   MSETCL Maharashtra State Electricity Transmission Co Ltd,

---

when voltage gets down the current of motor increases. but according to Ohm's law voltage is directly proportional to current. plz explain

4 Answers   Maruti Suzuki, TATA,

---

what is the function of anti-pumping in circuit breaker?

20 Answers   Aditya Birla, INEL, NCC,

---

Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient?

3 Answers  

---

define differential current and restraining current in relays. how to calculate it by mathematically? post the formulaes.

4 Answers   Siemens, VPEC,

---

what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer

1 Answers  

---

what is voltage

7 Answers   TCS,

---