Answer / reddy

we can use any number of phases for supply....but we maximum
use 3phase supply because.. as tht number of phases get
increase system complexity increases... so 3phase is
efficient among them....

Answer / partha

3 is the minimum phase no, which can balance the load easily.

Answer / md.mosaddak kabir

it is world wide standard.Thats why we use three phase
system.but its not so much logical answer.i think another
reason.we are producing electricity by alternator.so when we
use four or five phase system we have to change the design
of alternator.Then we should change pole,winding
everything.That is may be totally unbalanced.and if it is
possible it will not be cost effective.so we use three phase
system

Answer / hem

3phases are adequate
to produce rotating
magnetic flux in
induction&synchronous
motor and no need for
further phases as well
as economically

Answer / lokeshraj

Bcz it is most efficient to transmit 3 phase, 3 wire
supply..

Answer / usman

in three phase configuration all of three phases are equally distant ,with respect to their angular position 120 degree apart, from each other and voltage b/w any two phases is equal viz designated by Vl_l and three phase configuration is balanced.

Answer / rajib mistry

i think to balancing phase angle we have to use three or
more than three phase but for simplicity we use three phase.
as per example need not use capacitor to start a three
phase induction motor but for single phase system we need a
capacitor to start the motor.

Answer / volkan

As i know there is no particular reason for using 3
phase.Its only accepted as a standard.Thats why.
The possibilities for phase number is mathametically infinite.

What is proportional controller?

0 Answers  

What is the difference b/w Earthing and Grounding?

4 Answers  

why CT out put is 5 what ever the primary current.

2 Answers  

what is creep of energy meter?

2 Answers   HNG,

What is non-minimum phase transfer function?

0 Answers  

sir i want previous entrance exam papers for written test

0 Answers   Vizag Steel,

What should be the setting of an earth fault relay.

2 Answers   HP,

Electrical breakdown strength of an insulating material depends on............?why because?

2 Answers  

Can we check ELCB constantly from R1 to R8 phase in 1 no DB?

0 Answers   Legrand,

From, which load current range ( upper - lower limit current)can Air circuit breaker used for in electrical circuit.

4 Answers   ABC,

Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632

0 Answers  

what are the standard values for resistances(Megger testing) between L&N, L&E and N&E (L=Live,N=Neutral, E=Earth)?

1 Answers