Why we use three phase world wide why not four phase or
five phase being used?
Answer Posted / lokeshraj
Bcz it is most efficient to transmit 3 phase, 3 wire
supply..
Is This Answer Correct ? | 2 Yes | 8 No |
Post New Answer View All Answers
how to discharge 3 phase power factor correction capacitors
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
what is inverter and converter
How to calculate multiplying factor of dc energy meter
How 48-relay (incomplete sequence) functions?
what is zinc diffusion?
what is ramping rate of generator
brief notes on ammeters
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
how many types are their in switchyard or substation(like D,I TYPE), what is differant between them
what does a k rating in a transformer means?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?