Is there any thumb rule for cable selection for any current
rating ?
Answer / subhendu
Normally by thumb rule we can take, for Al cable it is 1.5 times(Amp) of its sq mm size, and in copper cable it is 2.5 times .
| Is This Answer Correct ? | 2 Yes | 0 No |
What is the purpose of reactor.why we used in over head line?
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
why can tv operate at low voltage??
IP55 protection stands for
How current is reduced in STAR connection?
xlpe cable 4 core nuetral wire is small why ?
* Signal transmission in sky wave propagation is due to ? a) Reforction of wave b) Reflection of wave c) Pierus through Inosphere d) None and Reason for this is????
what is the role of frequency in electrical system
why most of the induction motors are delta connected?
What is PTZ Camera???
3 Answers Cherrytec, CSC, Honeywell, Zicom,
direction of tarbine& genrator
how to calculate no load losses units comsumed by transformer
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)