Answer / dushyant bais

Flywheel is used to store energy the power stroke.
because after the power stroke the energy needed by the
piston to complete the other three stroke will be given by
the flywheel.thts why to store a big amount of energy the
size of flywheel is kept big.

Answer / prasad kangude

flywheel is used in ic engine to reduce fluctuation in
speed by absorbing &releasing energy duing power&3remaining
strokes respectively. energy stored in flywheel is directly
proportinal to mass moment of inertia (mk2)so it is big in
shape

Answer / kapil

flywheel is used to store the energy and supply it when there is a variation in speed,like in IC engines where the 3 strokes other than power stroke are idle strokes...
energy stored in fly wheel is directly proportional to the moment of inertia i.e I=mk^2.
where m=mass of fly wheel.
k=radius of gyration(i.e radius of flywheel)
if k value is high, amount of energy stored vll be high, so obviously size of the flywheel vll be big.

Answer / sooraj

It is a heavy wheel mounted on the crankshaft of the engine.
It minimizes cyclic variation in speed by storing the energy during power stroke and same is released during other stroke

Answer / nallani naveen

Flywheel is a rotating device, used in the engines. It is used in reciprocating engine. After the power stroke the energy needed by the piston to complete three power strokes, we use the flyweel

Answer / vironika

Fly wheel is a rotating device having a large wheel to maintain inertia after the power stroke the energy is released by the piston that energy must be calculated

Answer / tutul

fly wheel is used to maintain inertia. size is big coz to
provide more torque

Answer / gopal manda

flywheel is used in IC engine because it support to running
of the engine continue and share the engine load.if load is
increase instantly.then it support the engine
running.otherwise engine maybe stop.big fly wheel is use
because it angular force is directly proposnal to it size.

What are the compressor and types?

0 Answers  

Although the secondary loop of a PWR is a closed loop but some noncondensible gases are entrained into the secondary feedwater. Write three probable sources of these noncondensible gases.

1 Answers   Trinity Technologies,

Is the unit and normal value fuel ratio of an average diesel engine?

0 Answers  

An engine operates between temperatures of 900 K and T2. And another engine between T2 and 400 K. For both to do equal work, the value of T2 should be

3 Answers   BITS,

which material is suitable for punching press to avoid scratches amd waear of metal hittimg the blades?

0 Answers   Delta Thermoformers, Tata Steel Limited,

one kg of gas is compressed adiabatically from 1 kg/sq.cm,1 cubic metre volume and 300 kelvin to 5 kg/sq.cm,0.5 cubic metre and 400 kelvin.work transfer in this process will be

0 Answers   MAHINDRA,

Where can you find the feed check valve and feed stop valve and give the purpose of it?

1 Answers   RRB,

workingh principle of valve timing chart for cummins engine

0 Answers  

what is punching force required for embossing of depth 3.5mm and diameter 58mm

0 Answers   Omkar Solar System,

how can I masurement the circale weight ? like- 312mm i/d x 392mm o/d x 6mm thick.

0 Answers   Narmada Sugar,

how much 1kn of 1hp

2 Answers   ABB,

what is there in altenator which produces electricity?

1 Answers   Torrent Power,