Interested to Buy Any Domain ? << Click Here >> for more details...
why Flywheel is used (Need technical answer)? why generally
flywheel is big in shape?
- 8 Answers
- 25425 Views
- Ford, HCL, I also Faced
- E-Mail Answers
Answer Posted / nallani naveen
Flywheel is a rotating device, used in the engines. It is used in reciprocating engine. After the power stroke the energy needed by the piston to complete three power strokes, we use the flyweel
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is orthographic drawing?
Mention two types of dislocations.
What is burnt-out point ?
how can I calculate daya of pump
What is acceleration
Name the machines you know?
what is Retainer?
How does hydraulic clutches work?
Where can i see model papers for NLC graduate engineer test and RRB section engineer test
What are the examples of mechanisms?
SIR, PLZ GIVE ME INFROMATION FOR WRITTTEN TEST AND PI IN ISRO AHMEDABAD (MY MAIL ID:-ppdave@yahoo.com)
Is a diesel engines maximum rpm limited by the diesel burn rate?
Identify the parts of indicator diagram?
How do you reset the circuit breaker?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
