we have 3*1 MW generator one NGR is common for all it will
be selected during paralle our problem is two generator ca
be paralled but when slecting third one we need to close
NGR selection on third one other wise voltage not matching
why?
Answer Posted / k.prakashchandra
To establish relationship between I/C generator and the grid / bus bar/ other two gen through earth
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How can we choose the rating of submersible motors
This is urgent!! What is a Thyristor-based 3-ways selector switch with Zero crossing control? how does it operate and where is it mostly found in a system?
why it is so called as xlpe(cross linked poly ethyline) cable?
Hi Suppose we have a wye/wye transformer which is grounded at both sides,in this situation, do we have ay ground transformer? in other words, ground transformer can do any thing more (while we have nuetral wire in both sides)? As the last question, what about 3rd harmonic? we have two choices: first using wye/delta transformer + ground transformer and second using wye/wye earthed connection.in the former choice, we dont have 3rd harmoonic at the secondary side but what about Yn/yn conection? do we suffer from 3rd harmonic in the Yn/yn connection?
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
what r substations?what r there work?why voltages r incresed and then reduced during distribution of power
How much load can take a 16 mm aluminum cable 3 phase
Why GRR starts from 60% of motor speed why not less than 60%?
what is meant by 3rd hormonics ?
How much earthing frequency is capable?
Transmission voltage is kept 11KV,33KV,66KV,132KV,220KV due to form factor. What happen to 400KV and 765KV transmission voltage?
How to assume answer to electrical questions
What are the advantages and disadvantages of closed-loop control system?
What is slope...? Explain slope 1 and slope 2...?
What is the purpose of stablization resistor in high impedance bus bar protection