Answer / naresh reddy

each plate calculated p d 2 v

If one d.g. is unable to take full load of system, then second d.g. will take care of partly Load.for this condition RPM of both DG set should be equal.By using Synchronization panel RPM of dg sets are match, is it true?

1 Answers  

---

difference between fleming's left hand rule and RHR briefly.

3 Answers  

---

transformer test

4 Answers  

---

I am having a DG set.The 415 V from Generator is step up to 460 v and then the same is used for Induction furnace. before Step up, I am connecting LT load to my factory use. When Induction furnace is in service from DG, when i try to start a motor, the generator is tripped.Please tell me the reason.

3 Answers  

---

Dear,  How much ph is maintained of water electrolite used in lrs for slipring induction motor ?

1 Answers  

---

Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.

0 Answers  

---

Do I need a special Transformer to put 240 VAC 3 phase into it and and get 480 VAC 3 phase out of it to run a machine? Or, do I just use an ordinary step down transformer and step up the voltage? Thanks

2 Answers  

---

Will any motor burn if voltage provided is lesser than the rated voltage???? If yes, then how is speed control possible with voltage control

0 Answers  

---

what is the suitable voltage of transmission line to transmit 10000w power through 250 km. (a)11kv (b)33kv (c)66kv (d)132kv ]and please tell me whats the logic behind it

7 Answers   ONGC,

---

What is Fire Panel ? How it works ?

0 Answers  

---

How can we calculate the resistance of earthing & how can we control it?

2 Answers  

---

IF THE OUTPUT OF A 100KVA, 415V GENERATOR IS STEPPED UP TO 11KV WITH A 500KVA TRANSFORMER,CAN THE TRANSFORMER BE LOADED ABOVE THE SOURCE GENERATOR RATING?

4 Answers  

---